Liberty Hawthorne Concrete

Concrete Contractor in Lynwood, CA - Driveways, Steps and Slabs Built to the Estimate

Raised paved patio with curved stone retaining wall, broad steps, pergola, seating, and a circular fire pit.
  • Fully licensed and insured.
  • Free on-site estimates.
  • Expect a reply within 1 business day.

What Lynwood driveways, walks and steps need from us

We're based in Hawthorne, and Lynwood is one of the cities around it where our crew pours driveways, patios, front walks and steps. Most of the calls I take from Lynwood come from homeowners on single-family lots with a driveway that has cracked or sunk, a walk lifting at the seams, or front steps leaning away from the porch, and it's the same work we do in Carson.

On many of these lots the driveway is narrow and runs along the side of the house, so a truck can't always reach the pour and the old slab has often been patched more than once. That's why I plan each job around getting the old concrete and soft base out cleanly before we talk about the new surface.

What concrete in Lynwood usually runs into

  • Driveways that have sunk

    Sinking slabs usually sat on loose fill that was raked flat. We dig to firm ground and pack the subgrade, the soil the slab rests on, so the new one doesn't settle with the dirt.

  • Water running toward the house

    Pooling by the garage or along a wall usually means the old slab tipped toward the house. I check where the water should run before we set forms, so the new slab sheds it away.

  • Cracks in the wrong places

    Cracks wandering across a slab usually mean control joints, grooves that tell concrete where to crack, went in late or not at all. We cut them on time, so cracking follows lines we chose.

  • Steps pulling from the house

    Front steps that tilt or pull away from the porch usually sat on too little base to carry their weight. Our concrete steps construction work starts with packed ground under the new set.

Should you repair or replace a Lynwood driveway?

If the slab is still level and the cracks are thin, it usually doesn't need replacing, and I'll tell you so when I come out. When one panel has sunk or broken up, we can often use concrete cutting to take out just that piece along its joints and pour a new one, which leaves the rest of the driveway alone.

Once the whole slab tilts, breaks into pieces or sends water toward the house, the trouble is underneath, and I'd replace it, because patching the top won't reach it. If the budget is tight, I'd keep the money in a dug-out, packed base and save on the finish, since nobody sees the base on the day we pour, but it's what decides whether the slab stays flat.

Lynwood concrete questions, answered

  • How do I get a building permit for concrete work in Lynwood?

    Building permits in Lynwood come from the city's Building and Safety Division, which reviews plans for building, repairing or changing any structure in the city and inspects the work against the codes. The city's permit list names jobs like re-roofs, water heaters and solar but not concrete work, so whether your job needs one is a question for the division. If it does, I'll tell you at the estimate, and we handle the application and arrange the inspections.

  • Do I need a separate permit to redo my driveway apron or sidewalk in Lynwood?

    Yes, if the work reaches into the city right-of-way, the strip along the street the city controls, because an undated city submittal sheet says that work needs its own encroachment permit, outside the building division's plan review. The apron where your driveway meets the street and the public sidewalk are often in that strip, so I look at where your job meets the street and tell you whether this applies.

  • When do I need a grading permit in Lynwood?

    An undated city submittal sheet says a separate grading permit is required once 25 yards or more of soil is disturbed. A typical driveway, patio or walk usually moves less dirt than that, but a large backyard slab, a retaining wall or a foundation can come closer, so I work out the dig-out before we start and tell you if the grading permit comes into play.

  • Does my concrete contractor need a state license in California?

    Yes, in most cases, because the Contractors State License Board requires a current license from anyone who contracts for work that needs a building permit, uses employees, or is worth $1,000 or more in combined labor and materials. The board's exception covers only someone who doesn't advertise as licensed, needs no permit, uses no employees and stays under that $1,000 total. We're fully licensed and insured, and I'm glad to go over that with you.

  • How do I check earthquake hazard zones for my Lynwood address?

    You can type your address into EQ Zapp, the state geological survey's map tool, and it shows whether your property sits in any of the survey's mapped earthquake hazard zones. If it does, please mention it when I come out, since it's worth knowing before we plan a foundation, footings or a retaining wall.

  • How much does concrete work cost in Lynwood, and what changes the price?

    Your price comes down to the size of the slab, how much old concrete and soil has to come out, how much base work the ground needs, whether a truck can reach the pour and the finish you choose, so I'd rather measure than guess. The schedule turns on whether a permit applies and on curing, the days fresh concrete needs to gain strength before you walk or drive on it. Your written estimate lists what's included and what isn't, line by line.

Don't see your city? Please call

Choose your city below if it's listed, and if it isn't, please call (424) 307-8166 and ask, since we work in many cities around Hawthorne.

Get a free estimate for your Lynwood job

Tell us what you'd like poured or replaced and where, and we'll reply within one business day so I can come out and write your free, no-obligation estimate.

(424) 307-8166